Taking Into Operation; Maintenance - Eaton Crouse-Hinds LLK 98 018/18 Betriebsanleitung

5.

Taking into operation

- Prior to operation, check the light fitting for its proper functioning and
installation in compliance with these operating instructions and other
applicable regulations!
- Only carry out insulation measurements between PE and the external
conductor L1(L,L2,L3) as well as between PE and N!
- measuring voltage: max. 1 kV AC/DC
- measuring current: max. 10 mA
- Only operate the light fitting with complete closed protective bowl.
6.

Maintenance

Observe the national regulations applicable to the maintenance,
servicing and test of electrical apparatus as well as the general rules
of engineering.
6.1 Servicing
When servicing, in particular those components that affect the type of
protection, will have to be checked, e. g.:
- Housing and protective bowl for any cracks or damages.
- Gaskets for their perfect condition.
- Terminals and blanking plugs for their firm fit.
- Because of the risk of an electrostatic charge, the light fitting shall only
be cleaned with a damp cloth or sponge!
Only use customary household washing-up liquid diluted in water as
specified! The water temperature may be max. 50ºC. After that, rinse
with clear water to prevent the risk of tension cracks in the protective
bowl!
- Lamp replacement: Keep replacement intervals as specified by the
lamp manufacturer!
6.2 Repair
Prior to replacing or removing any components, observe the
following:
Cut the apparatus off the voltage before opening it or carrying out
repairs!
Only use certified genuine CCH/CEAG spare parts!
(See CCH/CEAG spare parts list).
Subject to alteration or supplement of this product series.
Regarding waste disposal, observe the relevant national regulations!
All components are marked with relevant material signs.
10
Industrial Luminaire Series: LLK 98
GB