Prior To Use; Installing The Software; Installation On Windows - Silvercrest SND 3600 B1 Bedienungsanleitung

SilverCrest SND 3600 B1

Prior to use

Connect the digitizer via the USB cable to a USB port on your computer. To do
so, insert the small plug of the supplied USB cable into the mini-USB socket (4)
of the digitizer and the large plug into a USB port on your computer. Once the
USB connection to the computer has been established for the first time, the
drivers are installed automatically. This process can take approx. one minute.
The power LED (2) lights up once the digitizer has been connected correctly.

Installing the software

Installation on Windows

WARNING! Important files may be overwritten and altered
during the installation of the software. You should back up the
contents of your hard drive before installing the software so
that you can still access your original files if there is a problem
after the installation.
Proceed as follows to install the software:
 Insert the supplied CD-ROM and the installation menu will open
automatically.
 Click on the "Installation" button to start the installation.
 Install the software according to the instructions on the screen.
If the setup wizard does not automatically start when the CD-
ROM is inserted, then the autorun function of your CD drive is
deactivated. Then proceed as follows:
 Open the root folder of the CD-ROM.
 Then start the autorun function by double-clicking with the left mouse
button on the autorun application (Autorun.exe).
32 - English