Emptying The Collector Box; Overload Protection; Restart Prevention; Working Methods - FLORABEST FLH 2800 B2 Originalbetriebsanleitung

4. To start returning material, press
the function switch (8) upwards.
Then, press and hold the "ON"
switch (9) to start the motor.
Releasing the "ON" switch will
turn off the machine.

Emptying the collector box

Do not leave it until too late to empty
the collector box (16). Remember
that the collector box fills unevenly
under the ejector opening.
1. Switch the shredder off. (see"
E
switching the shredder on and
off")
2. Unlock the collector box (16) by
placing the safety switch (3) in
the OFF position. (see Fig. E)
3. Remove the collector box (16)
from the chassis (15) and empty
it.
4. Make sure that the area around
the safety switch ( 3) is free of
wood chippings before you
reattach the collector box (16).
5. Reattach the collector box (16 )
and place the safety switch (3) in
the ON position.

Overload protection

In the event of overload, e.g. due to
branches that are too thick, the equipment
automatically switches off.
The overload protection switch (11) is
motivated and the Power-On indicator (12)
turns off which means power off.

Restart prevention

After switching off automatically as a result
of overload, the equipment will not restart
automatically.
After 1 - 2 minutes, to press the Overload
protection switch(11 ) to repower the
mahcine.
The Power-On indicator (12) turns red
which means power on.

Working methods

General working instructions

Keep enough distance to the
shredder since long branches
can be spun off while being
drawn into the shredder.
Wear ear and eye protection
Wear hand protection
• For safety reasons, the shredder will not
operate without a correctly attached
collector box (16).
• Keep hold of branches while feeding
them into the shredder until they are
automatically drawn in.
• Be aware of the possible intake speed
of the cutter and do not overload the
equipment.
• Do not allow shredded material to
accumulate near the ejection area. This
may otherwise hinder proper ejection
and force the material back up through
the funnel feeder.
GB IE NI
107