Connections - Geonav 4c Bedienungsanleitung Und Installationshinweise

Installation and Precautions
• Autopilot: To connect the GEONAV to an autopilot, use the
optional NMEA data cable (see the C o nn e c t i o n s Section).
• Depth sounder: To connect the GEONAV to a depth sounder,
use the optional NMEA data cable (see the C o nn e c t i o n s Sec-
tion).
Fixed mounting
The plotter can be mounted on any surface using the mount-
ing bracket provided with the unit (see figure).
Use 4 countersunk head screws (4mm) to fix the bracket to
the desired mounting surface. Since the bracket does not al-
low any left or right rotation, make sure that the unit is prop-
erly installed for the best view angle.
English

Connections

10
CONNECTIONS
Power supply
The GEONAV can be powered by us-
ing the appropriate power supply
cable with car lighter plug or the
built-in battery pack.
Install the power supply cable with
the connector in the position shown
in the figure, then exert a light pres-
sure until clicking.
To remove the cable, extract the ring
nut without rotating it.
When the cable is disconnected, make
sure that the connector is protected
by the appropriate rubber cap.
External power supply
The car lighter adapter has a little
lamp (LED) that goes on if the car is cor-
rectly providing power to the bracket.
If the lamp is off:
• check that the 12V voltage is available
from the lighter plug;
• open the adapter and check the fuse.
If the fuse is broken, replace it with a fuse
having the same electrical characteristics.
DO NOT USE ANY BYPASS CIRCUIT.
The fuse ensures that the special protec-
tion circuit inside the plotter works prop-
erly in case of accidental short-circuit, po-
larity inversion and overvoltage.
11
fuse
LED
English