Usb Connection - Geonav 4c Bedienungsanleitung Und Installationshinweise

Autopilot
AUTOPILOT
The GEONAV allows a boat equipped with an autopilot to fol-
low automatically the entered route, compensating for any
diversion caused by external conditions (wind, currents, etc.).
The GEONAV will display the "PROXIMITY TO WAYPOINT"
message to warn the user that the boat is about to reach the
target waypoint.
The GEONAV will display the "END OF TRIP" message to
warn the user that the boat is about to reach the last waypoint
in the route.
IMPORTANT: In order to avoid sudden change of course, it is always recommended
to deactivate the autopilot when editing and/or creating a route.
English

USB Connection

60
USB CONNECTION
The GEONAV can be connected to the USB port of a Personal
Computer.
Thanks to the USB connection, you will be able to install the
GEONAV software upgrades and transfer the data (routes,
tracks and markers) from the unit's CompactFlash™ to the
PC, and vice versa.
To be able to connect the unit to the USB port, the following is
required:
• USB cable of the GEONAV 4C;
• GEONAV 4C with CompactFlash™;
• a PC with USB port and a Windows release supporting the
mass storage devices on USB (Windows XP).
IMPORTANT: Some old releases of Windows (Windows 98 and Windows 95) do not
support USB connections of this type.
To carry out the USB connection:
• switch the unit on;
• select SETUP, then START USB;
• connect the unit to the USB port on the PC by the USB
cable.
IMPORTANT: You are recommended to select START USB from the SETUP menu
before connecting the USB cable to the PC.
From now on you will be able to access the CompactFlash™
on the GEONAV from your PC, as if it were any disk unit, as
well as transfer the data file from your PC to the unit, and
vice versa.
WARNING: Be cautious not to remove the chart data from the NAVIONIC folder of the
CompactFlash™.
61
English