Peiying PY-GPS5013 Bedienungsanleitung Seite 21

Note: Start engine before connecting it to the device to avoid
overload power surge during ignition and damage to the device.
Pull it out when you switch off the engine.
With a USB Adapter
Plug the adapter into wall AC power socket and connect to device
with the USB plug.
Caution:
1. A new battery will reach its best performance after a number of
cycles of recharging and discharging.
2. If the device is not in use for a long time, it is better to recharge
it to full capacity every 2 or 3 months to, avoid over-discharging
of Li-Polymer battery.
3. Warranty is not covering over-discharging of Li-Polymer battery.
4. Do not recharge the device under direct expose to sunlight for
long period of time.
GPS Test and Satellite Signal
For your first GPS test, please go outdoors to an open area away
from tall buildings and trees where you can see the sky. Acquiring
satellite signals can take a few minutes depends on environment
and satellite signal.
Reset
The reset key is at the backside of this device.
AV-IN
The device has a Jack 2,5 4 pin video input. Plug standard: NOKIA
Please note: below illustrations and descriptions
concerning OS are for reference only, and may vary
from actual software on your device!
Owner's manual
EN
21