Rectifying Faults; Notifications On The Display Panel - Siemens TQ5 serie Gebrauchsanleitung

en Rectifying faults
Errors
No milk intake by the milk sys-
tem.
Appliance is not dispensing
hot water.
Milk system cannot be as-
sembled or disassembled.
Appliance is not dispensing
drinks.
There is dripping water on the
inner floor of the appliance.
Brewing unit cannot be re-
moved.
Appliance cannot be oper-
ated.
Change displays.
Grinder won't start.

Notifications on the display panel

Errors
Display shows "Close" despite
the fact that the door is
closed.
Display shows "Please empty
drip tray and reinsert." despite
the fact that the drip tray is
empty.
68
Cause
Milk system is soiled.
Order of assembly is wrong.
Air is in the water filter.
Drip tray was removed too
soon.
Brewing unit is not in the re-
moval position (e.g. frost pro-
tection activated).
Appliance is in demo mode.
Appliance is too hot.
Cause
Door is not properly closed.
Appliance is too hot.
Appliance is switched off and
does not detect emptying.
Drip tray is soiled.
Troubleshooting
▶
Check whether the milk tube is im-
mersed in the milk.
▶
Clean the milk system in the dish-
washer.
→ "Cleaning the milk system",
Page 62
▶ First connect the milk system and
then the milk container. When disas-
sembling, you must first remove the
milk container and then the milk sys-
tem.
Immerse the water filter in water with
1.
the opening facing upwards until no
more air bubbles escape.
Reinsert the filter.
2.
→ "Insert water filter", Page 57
▶
Firmly press the water filter straight
down into the tank connection.
▶
Wait a few seconds after the last
drink was dispensed before removing
the drip tray.
▶
Switch the appliance back on.
▶
To deactivate demo mode, press and
hold for at least 5 seconds.
▶
Wait 1 hour so the appliance can cool
down.
Troubleshooting
▶
Press the door firmly shut.
▶
Wait 1 hour so the appliance can cool
down.
Switch the appliance on, and remove
1.
the drip tray.
Re-insert the drip tray.
2.
▶ Clean the drip tray thoroughly.