Cleaning Brewing Unit; Cleaning The Milk System; Using The Descaling Programme - Siemens TQ5 serie Gebrauchsanleitung

en Cleaning and maintenance
If you accidentally interrupt the ser-
¡
vice programme, you must reset it.
→ "Resetting a service programme",
Page 64
Tips
If you use a water filter, this prolongs
¡
the time interval until a service pro-
grammes needs to be performed.
You can combine the cleaning and
¡
descaling programmes using the
calc'nClean service programme.
→ "Using calc'nClean", Page 65
Clean your appliance with a soft,
¡
damp cloth immediately after a ser-
vice programme to remove any de-
scaling solution residues and pre-
vent corrosion.
Resetting a service programme
Take the following steps if the service
programme is interrupted, e.g. due to a
power failure.
Rinse out the water tank.
1.
Fill the water tank with fresh, non-
2.
carbonated water up to the "max"
marking.
Press ⁠ .
3.
The appliance will rinse itself for ap-
a
prox. 2 minutes.
Empty and clean the drip tray.
4.
Insert the drip tray and close the
5.
door.
Restart the service programme.
6.
Using the milk system cleaning
programme
Rinse the milk system with water, if ne-
cessary. The rinsing process takes ap-
prox. 1 minute.
Requirement: The brewing unit is
cleaned.
→ "Cleaning brewing unit", Page 62
Press ⁠ .
1.
Use and
2.
and care" and press
64
to select "Cleaning
⁠ .
Use and
3.
tem" and press
To start the programme, press
4.
The display will guide you through
a
the programme.
Remove and empty the milk con-
5.
tainer.
Clean the milk container, milk tube
6.
and suction pipe.
Fit the components and insert the
7.
milk container.
19
→ Fig.
Place an empty glass under the out-
8.
let system and press
The milk system will now clean itself
automatically.
The program has ended and the ap-
a
pliance is ready for operation.
Tip: If you want to clean the milk sys-
tem particularly thoroughly, clean regu-
larly by hand.
→ "Cleaning the milk system", Page 62

Using the descaling programme

Run the descaling programme when
your appliance prompts you. The pro-
cess takes approx. 30 minutes.
Requirement: The brewing unit is
cleaned.
→ "Cleaning brewing unit", Page 62
Press ⁠ .
1.
Use and
2.
and care" and press
Use and
3.
and press ⁠ .
To start the programme, press
4.
The display will guide you through
a
the programme.
Empty and insert the drip tray.
5.
Remove and empty the milk con-
6.
tainer.
Clean the milk container, milk tube
7.
and suction pipe.
to select "Milk sys-
⁠ .
⁠ .
to select "Cleaning
⁠ .
to select "Descale"
⁠ .
⁠ .