Teesa TSA3540 Bedienungsanleitung Seite 21

Owner's manual
3. Remove the blender connector cover from the main unit.
4. Install the blender to the main unit (put on and rotate the blender as indicated on the
markings at the main unit under the blender connector cover).
• When the blender connector cover of the device is removed but blender jug has not
been installed, the device will not start operation.
3
5. Rotate the blender in opposite direction after finishing mixing to disassemble the
attachment.
Notes on using the blender:
• Never put your hand or any object inside the blender while it is running.
• To add liquid ingredients during blending, pour them into the blender jar through the
hole by removing the measuring cup.
• It is suggested to precut ingredients into small pieces before processing them.
• Do not overfill the jar! Put the ingredients in the blender jar within the maximum level
indication.
• To achieve the best result when blending thick products, fill the blender jar half full only.
1. Insert the worm shaft in the cutter housing. Fit the cutter blade on the shaft with the
cutting edges outside. Place the selected disc over the blades ensuring the pin fits in the
cut-out. Fix the screw ring on the cutter housing. Check the assembly, the shaft should
have no play nor be able to turn on itself.
2. Remove the mincer connector cover.
3. Insert the mincer attachment, titled to the right, to the outlet and engage it fully. Return
the feed tube to a vertical position by turning to the left until it stops.
1
4
MINCER
2 3
21
EN