Getting Started - Gioteck EX-06 Bedienungsanleitung

GETTING STARTED

CHARGING
It is recommended to fully charge the headset before first use.
1] Plug the small connector end of the charging cable into
2] The LED on the headset will turn RED while charging and be OFF
QUICK-START SETUP
1] Connect the Wireless Transmitter into a USB port on your
2] Turn the headset ON by pressing the Power Button and the LED will flash
3] Turn the headset OFF by pressing the Power Button
Please read the next few pages for more in-depth set-up instructions.
PAIRING
The headset should pair automatically. However, if your
headset has not paired successfully the LED on the Headset
and the Wireless Transmitter will flash intermittently.
To re-pair your headset, press and hold the mute button on the headset
until the LED on the headset and the LED on the transmitter both turn solid.
The headset should pair automatically on the next usage.
WIRELESS RANGE
The headset is effective up to a distance of 20-30 metres.
EX6UNI-wireless-manual-book.indb 4
the charging port on the headset and the other end into
a port on the front of your console, PC or MAC.
when fully charged. The headset will take approximately 4-5 hours
to fully recharge from a drained state. The charging cycle will
take longer If the headset is in use during charging.
When there is only 20 minutes of battery left, the LED on the
headset will flash blue continuously. This will continue until the
headset is charged or until the battery is completely drained.
console, PC or MAC. The Transmitter LED will flash Red.
blue. Connection between the transmitter and headset has been successful
if the Headset LED turns solid blue and the Transmitter LED is solid red.
and the LED will turn off.
PLEASE NOTE: You may need to make some adjustments
to your TV/Monitor's settings to enable the audio to
come through the headset (Consult your TV manual).
4
11/09/2013 10:24