JBL Artemio Set Bedienungsanleitung Seite 11

Proper disposal of this product
Within the EU, this symbol indicates that this product may not be disposed of with your
general household rubbish. Discarded appliances contain valuable recyclable materials
that should be recycled and kept from damaging the environment or human health
by uncontrolled garbage disposal. Therefore, please dispose of discarded appliances
via appropriate collection systems or send the appliance to the place where you purchased it for
disposal. They will make sure it is recycled properly.

Parts and description:
1. Stand
2. Brood container
3. Domed lid for brood container with O-ring
4. Air inlet; 4a extension hose
5. Air outlet with foam filter inside
6. Stopcock
7. Artemia sieve (also available separately as JBL Artemio 3)
8. Harvesting container (also available separately as JBL Artemio 2)
9. Air hose 4/6 mm
10. Aerator pump (JBL ProAir a50, 230 V, 50 Hz, 3W)
11. Non-return valve for air
12. Screws for wall mounting

Installation and operation of JBL Artemio Set
1. Select a suitable place to set up the equipment. If possible, the stand (1) should be placed in
a location which is not sensitive to water and is out of the reach of children. Alternatively, select
a place where the equipment can be wall-mounted, fixing the stand (1) with the screws (12)
supplied.
2. Open the domed lid of the brood container (3) turning clockwise (bayonet) and remove it
together with the extension hose (4a). Place the brood container (2) in the stand so that the JBL
logo and filling level mark are easily visible.
3. Fill the brood container (2) with tepid tap water (approx. 25 °C) up to the filling level mark
(500 ml). Put 2 measuring spoons JBL ArtemioMix into the brood container. Alternatively you
can also use 2 measuring spoons JBL ArtemioSal and 2 – 3 measuring spoons JBL ArtemioPur.
JBL ArtemioMix or ArtemioSal and ArtemioPur are available from your specialist retailer.
Then close the domed lid, turning anti-clockwise.
4. Using the air hose (9) provided, connect the air inlet (4) on the domed lid (3) to the aerator
pump provided (10). If possible, position the aerator pump above the water level in the brood
container. If the pump can only be positioned below the level of the water in the brood
container, fit the supplied non-return valve to the air hose, about approx. 5 - 10 cm away from
the air inlet.
5. Connect the aerator pump to the mains power. The mixture of salt, Artemia eggs and water
DE
GB
FR
NL
IT
DK
ES
PT
SE
CZ
PL
RU
11