Werbung
Operating instruction for electric fence controller ranger N40 / N60
(identical in construction to intelliSTOP N40 / N60)
in connection with SECURA ANIMAL or SECURA SECURITY safety hints
(www.horizont.com)
Installation and connection:
The installation is to be made at a location protected from weather and where there is no
risk of fire. The controller must be mounted in the vertical position. The earth lead must be
attached to the earth terminal (
The power supply cable must not be handled when the temperature is below 5°C.
If the fence lead is conducted away from the building a lightning protection must be
installed.
Operating and control:
Plug the mains cable in a 230 V supply socket. After a few seconds a slight tic-tac can be
heard. The control lamp (1) and the fence voltage level (2) flashes with the pulses.
If the control lamp (1) flashes with the the pulses energizer operates properly. If this lamp is
not or steady illuminated the energizer is faulty.
The 6 controllamps (2) indicate the fence voltage in 1000V steps. At least 3 lamps should
flash (3000V) to ensure sufficient voltage and fencing.
Possible reasons, when the voltage is too low:
with fence:
without fence:
The energizer has two fence terminals: (page 3 / fig. 2)
(Z1) = max output
Both outlets can operate separate fences at the same time. A short in the Z2 fence has no
strong influence on Z1 but a short or a deviation in Z1 means a further reduction of Z2.
By operating with two fence systems ( Z1 + Z2 ) the indication lamps show the reduced
output only.
Testing grounding (3):
Produce with a metal stake against the fence wire (no pla-
stic) a short circuit (ca. 50m distance to fencer).
Max. 1 lamp (wet ground) or 2 lamps (dry ground) may shine.
Otherwise drive in more stakes (see picture).
Service:
Servicing is only to be made by qualified service personell. Only by the manufacturer
commanded replacement parts must be used. If the supply cord of this energizer is
damaged this cord must be replaced by a special supply cord which is recommended
by the manufacturer.
), the fence lead either to the fence terminal (
heavy vegetation on the fence, insulator flash-over or fence too long.
the energizer is faulty, see service.
(Z2) = reduced output
en
or
).
5
Werbung
