Speed Calibration - B&G H1000 Bedienungsanleitung

speed calibration

speed calibration
Speed calibration sets the units of measurement, damping and speed calibration factor (Refer to the flow chart
detailed on the following page).
units
Boat speed values can be shown in knots, kph or mph. To change the units, highlight Unit and press ENTER. Using
the UP/DOWN keys, highlight the desired choice and press ENTER to memorise.
damping
Boat speed damping allows you to slow down the response of speed readings in rougher conditions by adjusting the
damping value from 0 to 9. For minimum damping, set the value to 0, for maximum damping, set the value to 9.
adjustment
Speed adjustment calibration is necessary to compensate for hull shape and paddlewheel location on your boat.
For accurate speed and log readings, it is essential that the paddlewheel is calibrated.
adjustment - auto
This procedure will automatically calibrate the boat speed and log readings ,and is the recommended method for most
boats. This procedure requires the boat to make consecutive runs, under power at a constant speed, over a known
distance.
adjustment - ref
Reference speed adjustment, allows for quick and easy calibration of your boat speed readings against a known calibrated
source; for example, speed over the ground (SOG) from a GPS, or, alongside another boat which has a calibrated log.
sea temperature units
o o
Sea temperature information can be displayed in either c or f. To alter the displayed units, highlight Sea temp in the
calibrations menu and press the ENTER key. Using the UP/DOWN keys, highlight the required choice, and press the
ENTER key to select.
www.bandgservice.co.uk