Electrical Connections - B&G H1000 Bedienungsanleitung

electrical connections

Front view of
male connector pins
GROMMET
2 3
5
1 4
CABLE TIE
www.bandgservice.co.uk
external connections
Two FastNet² connectors are provided at the rear
of the unit. These connectors allow connection to
the rest of the system for the supply of power and
data.
The table below shows pin functions.
Pin
Number
1
2
3
4
5
securing the cable (interface box)
Push the cable(s) from the sensor(s) through the
grommets until the outer insulation of the cable
just protrudes, fit the cable tie to prevent accidental
removal of the wires from the connector strip.
Signal
12V
Busy
FastNet²-
FastNet²+
0V