Basic Operations - Pioneer SVM-1000 Bedienungsanleitung

BASIC OPERATIONS

BASIC OPERATIONS
Channel fader
CROSS FADER
1 Set rear panel POWER switch to [ON].
2 Set the AUDIO INPUT switch for the desired channel to match
the type of connected component.
• When using the DVD input, set to [DVD].
• When using LINE input, set to [LINE].
• When using DVD/LINE input, set to [DVD/LINE].
• When using DIGITAL input, set to [DIGITAL].
• When using PHONO input, set to [PHONO].
3 Use the VIDEO INPUT switch for the selected channel to
choose the video input.
4 Use the AUDIO TRIM dial to adjust the input level for each
channel.
5 Use the VIDEO TRIM dial to adjust the input level for each
channel.
VIDEO
INPUT
AUDIO
INPUT
HI
HI, MID,
LOW
lever
ASSIGN
POWER
VIDEO MASTER LEVEL
VIDEO TRIM
AUDIO MASTER LEVEL
AUDIO TRIM
HI, MID,
LOW
10 10
9 9
8 8
BALANCE
7 7
6 6
5 5
4 4
3 3
2 2
1 1
0 0
Cross fader lever
(A/B)
6 Use the channel equalizer dials (HI, MID, LOW) to adjust the
tone.
7 Use the channel fader lever to adjust the sound volume of
the selected channel.
8 To use the cross fader on the selected channel, set the CROSS
FADER ASSIGN switch to either cross fader channel A or
channel B, and operate the cross fader lever (A/B).
• When not using the cross fader, set the CROSS FADER
ASSIGN switch to [THRU].
9 Use the AUDIO MASTER LEVEL dial to adjust the overall
sound volume.
10 Use the VIDEO MASTER LEVEL dial to adjust the overall
luminance level.
11 Use the BALANCE dial to adjust the sound balance between
right and left.
13
En