Using Your Product - Electrolux E4WMSTPN1 Handbuch

6

6. USING YOUR PRODUCT

Follow the steps below to prepare your Stain Remover Pen for use.
1. Connect the power cable to the pen.
2. Chose the correct plug and insert it into the power supply.
Plug the power supplyinto the outlet.
3-4. Mix some water and colourless fabric detergent (non-chlorine bleach).
The cap on the Stain Remover Pen can be used as a cup to fetch water.
5. Place a piece of cloth or clean paper under the garment to absorb the stain
residuals.
6. Add the water-detergent mixture, soaking the fabric in the stained area.
7. Always hold the pen in an upright position with the pen tip gently pressed on the
stained area. Do not use excessive force. Press and hold the button for as long
as the tip is on the stain. Make circular movements, passing the tip gently across
the full extent of the stain.
8. Add more water-detergent mixture as needed for best results.
The stain must always be wet to ensure the efficiency of its removal.
9. Remove excess dirt from the cloth and the tip of the pen with absorbing paper
or clean cloth.
10. Repeat the process from step 5 until the stain has been satisfactorily removed
or no further progress is made in removing the stain.
CAUTION! Don't use the device more than 1 minutes on delicate and dyed
fabrics.
11. After completing the pre-treating process, clean your pen and store it in it's
housing.
12. Wash the garment according to the care label to remove the stain residue from
the garment.
NOTE: Stain residues might remain on the garment after the pre-treatment with the
pen. To be fully effective, the pre-treated garment has to be washed according to
the care label.
1.
5.
9.
2.
6.
10.
1 - 3
min.
3.
7.
11.
4.
8.
12.
60% COTTON
40% POLYESTER
MACHINE WASH WARM
WASH DARK COLORS
SEPARATELY
USE NON CHLORINE
BLEACH
TUMBLE DRY LOW
MEDIUM IRON