Table 10: Menu Structure - DAB MCE-22/P Handbuch

Quick-view menu (visible)
Main menu User menu
mode
MAIN FR
(Main page) Minimum
of rotation
Menu selection
VP
Pressure
C1
Pump phase
current
PO
Power delivered to
the pump
SM
System monitor
VE
HW and SW
information
Identification colours

Table 10: Menu structure

ENGLISH
Monitor Setpoint
menu menu
set-minus mode-set
VF SP
Flow display Setpoint
pressure
TE P1
Dissipator Aux. 1 pressure
temperature
BT P2
Card Aux. 2 pressure
temperature
FF P3
Fault & Warning Aux. 3 pressure
Log
CT P4
Contrast Aux. 4 pressure
LA
Language
HO
Operating hours
Key
Modification of multi inverter unit parameters
Series of sensitive parameters. These parameters must be aligned to enable start-up of the multi-inverter system.
Modification of one of these parameters on any inverter will automatically align all other inverters without the
need for any command.
Parameters that enable facilitated alignment from a single inverter, transferring data to all others. It is admissible
that these differ between inverters.
Series of parameters that can be aligned in broadcast mode by one inverter only.
Setting parameters significant on a local level only
Read-only parameters
73
Full Menu (direct or password access)
Manual menu
set-plus-minus
FP
Minimum
Frequency mode
VP
Pressure
C1
Pump phase
current
PO
Power delivered to
the pump
RT
Direction
of rotation
VF
Flow display
Installer Tech. Assist.
menu menu
mode-set-minus mode-set-plus
RC TB
Rated Block time
frequency due to water failure
RT T1
Direction Shutdown time after
of rotation low pressure
FN T2
Rated Delay on shutdown
frequency
OD GP
Type Integral
of system gain
RP GI
Restart Integral
Pressure decr. gain
AD FS
Address Minimum
frequency
PR FL
Pressure sensor Minimum
frequency
MS NA
Measurement Active inverters
system
FI NC
Max. simultaneous
Flow sensor
inverters
FD IC
Pipe diameter Inverter config
FK ET
K-factor Max. exchange time
FZ CF
Carrier
Zero flow frequency
FT AC
Min. flow Acceleration
threshold
SO AE
Antiblocking
Dry running factor
Min. threshold
MP I1
Input 2
Min. dry running
function
pressure
I2
Input 2
function
I3
Input 2
function
I4
Input 2
function
O1
Output 2
function
O2
Output 2
function
RF
fault & warning
reset