Silvercrest SWV 300 C1 Bedienungsanleitung Seite 78

SilverCrest SWV 300 C1
No LAN connection
 Check whether the network cable is inserted correctly into the WAN/LAN socket (6) or LAN socket
(7) of the wifi range extender and into the LAN socket of your end device.
Connection with the WPS button fails
 Establish the connection with the WPS button again.
 Reset the wifi range extender to the factory default settings. Press the Reset button (5) for
approximately 10 seconds with a sharp object until the Power/WPS LED (2) goes out. This will reboot
the wifi range extender. The wifi range extender requires a certain amount of time (boot time) before it
is ready to use. Wait for approximately 30 seconds before using the wifi range extender. Then
establish the connection with the WPS button again.
 Eliminate sources of interference between the wifi range extender and the wireless router.
 The distance between the wifi range extender and the wireless router is too great, thus reduce it.
The configuration menu of the wifi range extender is not shown.
 The address http://repeater.setup was entered into the address line of the Internet browser
incorrectly; check and correct the entry.
 The configuration of the wifi range extender is incorrect. Reset the wifi range extender to the factory
default settings. To do so, press the Reset button (5) for approximately 10 seconds with a sharp object
until the Power/WPS LED (2) goes out. This will reboot the wifi range extender. The wifi range
76 - English