Manual Configuration - Silvercrest SWV 300 C1 Bedienungsanleitung

It is possible to configure multiple wifi range extenders. These should be configured
one after the other.
If your wireless router does not support WPS or the connection fails for some other reason, you must
manually configure the wifi range extender.

Manual configuration

There are two different ways to configure the wifi range extender.
If you are not using the network default settings on your computer and have
manually set an IP address, you must restore the network settings to Automatically
obtain an IP address. For further details, please read the operating instructions
for your computer.
1. You can then configure the wifi range extender via the network cable. If you want to configure the
wifi range extender via the network cable, you must connect the wifi range extender to your
computer. Use the network cable included with the device for this purpose. Insert one end of the
network cable into the WAN/LAN socket (6) or the LAN socket (7) of the wifi range extender and
the other end into the LAN socket of your computer.
SilverCrest SWV 300 C1
English - 25