mumbi m-RMF150/6 Bedienungsanleitung Seite 19

C
Linking up the smoke detectors
We recommend performing the registration of all smoke detectors on a table.
The following steps must be carried out within 20 seconds. Please read the instructions
before performing the individual steps.
1. Take a smoke detector from the group and designate it as the "master".
The remaining detectors are all assigned to be secondary detectors ("slaves").
2. Press the LEARN–button on the "master" detector several times until it lights up
green. (D)
3. Now press the LEARN–button on all the secondary "slave" detectors until they
light up red. (D)
4. Test: press the TEST–button (C) on the "master" detector until all the smoke detectors
emit a signal. At this point, the LED on the "master" detector will flash red and the
LEDs on the secondary detectors will flash green. After a few seconds the alarm
signal will stop. The smoke detectors are now linked.
Creating a large group
If the required number of number of devices cannot register within 20 seconds, then a
smaller group can be created first.
This group can then be expanded by adding additional "slave" detectors. For each
detector in the existing group, the TEST–button (C) can be pressed down until all the
other detectors react and the additional detectors are added to the group.
D
-19-