mumbi m-RMF150/6 Bedienungsanleitung Seite 18

A
Installation
1. Twist off the assembly plate from the smoke detector. (A)
2. Install the assembly plate to the assembly location (wall or ceiling).
3. Insert a 9V battery into the battery compartment (B) ➀ for the smoke detector.
4. Insert three AA batteries for the linking up into the large battery compartment (B) ➁
Before inserting the final AA battery, press first the red notch and then the final
battery down.
5. Place the smoke detector with the openings on the clips of the assembly plate and
twist until it locks in place.
Note: The smoke detector cannot be fastened to the assembly plate without batteries.
Installation test
Check all the installed devices by pressing the TEST–button (C) for a few seconds.
Release the button as soon as the alarm is triggered. The alarm will continue sounding
for a few seconds and then automatically stops. Now you can be sure that the device
functions properly.
B
-18-