Axis P3353 Installationsanleitung Seite 9

AXIS P33 Network Camera Installation Guide
Complete the installation
1. If the cables are routed along the wall, remove the side lid from the camera's dome cover.
2. Rotate the black protective shield inside the dome casing to match the camera's position (not
applicable to AXIS P3364-LV).
3. Clean the dome with a dry soft cloth to remove dust and finger prints and use a blower to
remove dust from the lens.
4. Mount the dome casing using the supplied tamper-proof screws and screw driver. Now that the
dome is in place, check that the camera is properly focused.
Note:
AXIS P3364-LV: Before attaching the dome cover make sure the optical shield sits well in place.
See image on page 8.
For the AXIS P3364-LV, when the lens holder is tilted at a certain angle the dome cover may block
part of the IR illumination. In that case:
• loosen the locking screw
• rotate the lens holder 180°
• tighten the locking screw
• for correct image orientation, rotate the lens by 180°; make sure the horizontal lines are aligned and the
mark between them is facing up.
The installation is now complete.
Side lid
Camera unit
Dome cover
Network cable
Dome cover
Page 9