Safety - Honeywell SmartDrive Compact Serie Schnellanleitung

1-EN
Honeywell
SmartDrive Compact User Manual available on the CD delivered with your

1. SAFETY

This quick guide contains clearly marked warnings which are intended for your per-
sonal safety and to avoid any unintentional damage to the product or connected ap-
pliances.
Please read these warnings carefully:
This quick guide includes the essential steps for easy
installation and setup of your SmartDrive Compact inverter.
Before commissioning your drive, read the complete
product or downloadable at:
http://ecc.emea.honeywell.com /inverter
ONLY A COMPETENT ELECTRICIAN IS ALLOWED TO
CARRY OUT THE ELECTRICAL INSTALLATION
The components of the power unit of the inverter are live when
SmartDrive Compact is connected to mains potential. Coming
into contact with this voltage is extremely dangerous and may
cause death or severe injury.
The motor terminals U, V, W (T1, T2, T3) and the possible
brake resistor terminals -/+ are live when SmartDrive Com-
pact is connected to mains, even if the motor is not running.
The control I/O-terminals are isolated from the mains potential.
However, the relay output terminals may have a dangerous
control voltage present even when SmartDrive Compact is dis-
connected from mains.
The earth leakage current of SmartDrive Compact inverters
!
exceeds 3.5mA AC. According to standard EN61800-5-1, a
reinforced protective ground connection must be ensured.
See Chapter 7!
If the inverter is used as a part of a machine, the machine
manufacturer is responsible for providing the machine with a
main switch (EN 60204-1).
If SmartDrive Compact is disconnected from mains while run-
ning the motor, it remains live if the motor is energized by the
process. In this case the motor functions as a generator feed-
ing energy to the inverter.
After disconnecting the inverter from the mains, wait until the
fan stops and the indicators on the display go out. Wait 5 more
minutes before doing any work on SmartDrive Compact con-
nections.
The motor can start automatically after a fault situation, if
autorestart function has been activated.
Safety 2