Installation; Transport; Installation Location - Reflex Storatherm Aqua Inox Serie Betriebsanleitung

5

Installation

WARNING
Risk of injury due to heavy weight
The tanks are heavy. Consequently, there is a risk of physical injury and accidents.
• Use suitable lifting equipment for transportation and installation.
CAUTION
Risk of burns
Escaping hot medium can cause burns.
• Maintain a sufficient distance from the escaping medium.
• Wear suitable personal protective equipment (safety gloves and goggles).
5.1

Transport

ATTENTION
Property damage during transport
Improper transporting procedures may cause damage.
• Fasten the device with suitable transport securing means such as straps.
For transport to the installation location proceed as follows:
1. Observe the marking on the packaging.
2. Only transport the tank in an upright position.
3. Move the tank carefully during transport to the installation location.
4. Set the tank down gently.
5. Only remove the packaging at the place of installation
5.2

Installation location

Ensure the following conditions are fulfilled for the installation
location:
• Frost safe room.
– In damp rooms, use a platform.
• Load bearing, level floor.
• Collection tray with connected drain.
• Allow for the minimum distances to the side and above.
• Take the position of the connections from the technical data.
see chapter 4 "Technical data" on page 16
Storatherm — 19.03.2018
Installation
English — 17