Safety Instructions; Properties - Sachtler Reporter 8LED Benutzerinformation

Reporter 8LED
1

Safety instructions

Á Do not use the Reporter 8LED in water!
Á Ensure that during the operation of the light that enough
clearance is maintained around the fixture that the heat
it generates can dissipate.
Á The light housing may not be covered with any material,
as this causes a reduction in the cooling, which will
cause a reduction of the LED life.
Á Handle with care! Do not dispose of fixture in the trash!
Note: An input voltage higher than 33 V will destroy the
electronics inside the light fixture!
2

Properties

Á The Sachtler Reporter 8LED is designed for use as on-
board camera light.
Á The LED light fixture can be operated on low voltage
ranging from 6 VDC until 24 VDC. The integrated electronic
assembly drives the LED with the necessary current.
Á The standard power cable has a 2 pin Anton/Bauer Power
tap connector. There are other optional adapter cables
available to make it usable with other power sources (see
Accessories, chapter 7).
Á Due to its small and very robust construction, the Reporter
8LED can also be used outdoors in harsh environments.
The housing is water resistant, and can be used in wet
conditions and spraying water (IP 44).
- 1 -
Benutzerinformation