Channel Test - Only Dmx Operating Mode; Led Status Display - Stage Line Dsp4Tr Bedienungsanleitung

DSP4TR
2.3 channel test – only DMX operating mode
Start address:
Manual on:
There is no special operating mode for channel test, the DIP-
switches S4.1 to S4.4 sets the channels 1 to 4 in ON state
independent from the DMX data.
3.

LED status display

PWR - LED(red)
DMX - LED (green) lit
SYS - LED (yellow) lit
K1- LED (yellow) lit
K2- LED (yellow) lit
K3- LED (yellow) lit
K4- LED (yellow) lit
16
001 – 512
DIP-switch S4.1 to S4.4
lit = supply voltage is on
= valid DMX512 signal
blink = no or faulty DMX signal
= system is running
blink = Stand-By, DIP S4.8 is ON
= channel 1 is ON
= channel 2 is ON
= channel 3 is ON
= channel 4 is ON