Stage Line DSP4TR Bedienungsanleitung Seite 15

These switches are coded in binary counting from the left to the
right and give the DSP4TR its start number.
Setting: 0-0-0
1-0-0
0-1-0
1-1-0
0-0-2
1-0-2
0-1-2
1-1-1
Example: Sequencer with 12 channels & 1s delay time
This needs three pieces of DSP4TR.
a) DIP-switch S4.8 set to ON at all devices
Only necessary if the sequencer operating mode has
been activated yet.
b) Set 801
c) DIP-switch S4.4 to ON position (
d) DIP-switch S4.1 - S4.3
e) DIP-switch S4.1 - S4.3
f) DIP-switch S4.1 - S4.3
g) DIP-switch S4.8 to OFF position at all devices, only if a)
With switching off the DIP-switch S4.8 the DSP4TR leaves it reset
mode and starts the sequencer operating mode. Now you can see if
your settings are correct.
Note!
The whole sequencer with all devices and delays will start first
when all DSP4TRs will be switched on simultaneously via their
power supply. Channel 1 of device 1 starts at once, then all the
other channels with 1 second delay.
(All channels are on after 11 seconds in this example)
= 1. DSP4TR, channel 1 to 4
= 2. device, channel 5 to 8
= 3. device, channel 9 to 12
= 4. device, channel 13 to 16
= 5. device, channel 17 to 20
= 6. device, channel 21 to 24
= 7. device, channel 25 to 28
= 8. device, channel 29 to 32
to the rotary code switches
01 x 1 second)
000 at the first DSP4TR
100 at the second DSP4TR
010 at the third DSP4TR
DSP4TR
15