Using A Diamond To True The Grinding Wheel; Grinding Wheel; Assembleinstructions With Drillattachment Aand B - KEF SLIBETTE 6 Bedienungsanleitung

2.5.5 Using a diamond to true the grinding wheel

Loosen the Allen bolt (19) and tighten the locking screw (17). Loosen the nut (13) and use the
round finger nut to set the stop (8) for the bit to approximately 5 mm from the grinding wheel.
Loosen the adjustment screw (16) for the clamp, and lay the holder containing the diamond in
the V-groove. Push the clamp carefully forward to touch the diamond holder, until the
diamond is approximately 2 mm from the grinding wheel.
Tighten the adjustment screw (16) again. Start up the machine. The arm can now swing
towards the centre.
True the side of the grinding wheel with very little tightening of the diamond using the
adjustment screw (7). Continue truing until the wheel is completely clean and smooth. Take
care not to let the diamond touch the flange or nut at the shaft end. Once the diamond is
removed you can prepare for bit grinding.

2.5.6 Grinding wheel

A cup wheel must be used. Grain sizes in the range 36 to 60 are recommended, of normal
corundum or precious corundum as required.
2.5.7 Assembleinstructions with Drillattachment A and B
26