Setup - KEF SLIBETTE 6 Bedienungsanleitung

2.1.3 Setup

Grinder/polishers must be set up on a secure, even surface. Then the
grinder/polisher must be fastened securely to the floor or onto a workshop bench by
means of the four holes that were used to attach the grinder/polisher to the pallet.
The electrical voltage used for connection must be within the stated voltages shown
on the motor plate.
The machine must be connected with reference to the electrical diagram (see section
7.6).
The task of electrical connection must be undertaken by an authorised electrician.
Check that the motor has the correct rotation direction (see arrow on the shield).
C
A
B
Fig.: 2.1.1
Prior to use, check that the grinding wheel (A) can rotate freely without becoming
loose. The grinding unit (B) must be adjusted so there is a distance of approx. 2 mm
between the unit and the grinding wheel. The eye guard (C) must be clean and in the
correct position.
All these checks and adjustments may only be performed if the machine is switched
off. When starting the grinder for the first time, run it at maximum speed for approx. 5
minutes before use. Make sure you keep a safe distance from the machine during
this time.
19