Connecting To Power Source; Parts - Swim & Fun Classic 300 Bedienungsanleitung

GB
In the event of guarantee claims please contact your dealer. When returning a defective product, it
must be packed in such a way that it is not damaged during transport. It is your responsibility that
the product arrives safely. You must state your name, address, phone number and preferably your
e-mail address. If the product are to be returned to you! Always remember to state what is wrong
with your product.
Beware!
Always make sure that the hoses on both suction and pressure sides are closed, so the
water never can get into the pump itself, if loosen the filter hose couplings. There is no
warranty for damages caused by flooding of the pump.
2

Connecting to power source

The pump must be connected to the electric network by a 30 mA differential switch. Always discon-
nect the pump from the electric network before carrying out any kind of operation on the filter or
pump.
Beware!
Prior to assembling and using this product, carefully read and adhere to all caution and
important notices located throughout this manual. Failure to comply with these instructi-
ons may damageto the product or cause serious personal injury or death.
3.

Parts

The filter system is made up
of the following parts (Fig. 1 and fig. 2.)
Pump (1),
7-way Valve (2),
Filter tank (5),
Tube with a manifold (6),
Hose between pump and filter tank (11)
(look inside the tube!),
Spigot (9),
Supporting base (10),
1 bag with: gasket (3), small sand
guard filters (7), drain valve (8),
manometer (not illustrated).
1 bag with parts for the pump:
2 stk. Hose connectors, 3 stk. O-rings, viewing glass, 2 pcs nozzles, and a manual.
MV-1030-1050-03-2019 . © All rights reserved Swim & Fun Scandinavia ApS
Fig. 1 Fig. 2
Side 35