In Shape 17523 Gebrauchsanweisung Seite 35

Lubrication
If the belt begins to run stiffl y, and it is not
because the belt is incorrectly tightened, it
should be lubricated using silicone oil.
Unplug the treadmill and lubricate the plate
beneath it using silicone oil.
Allow the belt to run unloaded for 3 minutes
to distribute the silicone oil.
If the belt runs unevenly
During operation, the belt may run to the
right or left if one of your legs is stronger
than the other. Always try to run in the
middle of the belt.
If the belt drifts to the left, loosen the left
adjustment screw and/or tighten the right
adjustment screw.
If the belt drifts to the right, loosen the right
adjustment screw and/or tighten the left
adjustment screw.
The belt must run at a speed of 6 km/h while
you make this adjustment.
You should only turn the screws a quarter
of a revolution at a time. Do not tighten the
screws too much, as this may damage the
treadmill.
If the belt slips
If the belt is too loose, it may slip on the
rollers or it may stop when a person steps on
it. Turn both adjustment screws clockwise
to tighten the belt. You should only turn the
screws a quarter of a revolution at a time.
Do not tighten the screws too much, as this
may damage the treadmill.
GB
35