Preparing The Printer - Canon PIXMA iP1700 Kurzanleitung

Preparing the Printer

Be sure to read your setup sheet first for setting up your printer and getting it ready for use.
1
Turn on the printer.
Caution
Be sure to remove the tapes and protective material before you turn on the printer.
Note
The tape or the protective material position is subject to change.
2
Prepare the FINE Cartridges.
Notes
Do not touch the electrical contacts or Print Head Nozzles on a FINE Cartridge. The printer may
not print out properly if you touch it.
Do not reattach the Protective Tape once you have removed it.
Handle the removed Protective Tape carefully to avoid getting your hands dirty or staining
surrounding work area.
3
Install the FINE Cartridge.
When you use the iP1700
Be sure to use the iP1700 with both Black and Color FINE Cartridges (PG-40, CL-41).
Otherwise, the printer cannot print. When either of ink runs out while printing, you can select
either Color or Black ink as a printer driver setting. However you must use the printer with
both Black and Color FINE Cartridges loaded regardless of the printer driver setting.
When you use the iP1300
The iP1300 is a model that can print only with a Color FINE Cartridge (CL-41).
By installing an optionally available Black FINE Cartridge (PG-40), the iP1300 can print using
both Black and Color inks just like the iP1700.
Important
Ensure that all the FINE Cartridges are installed in the order directed by the label. The printer
cannot be used unless all the FINE Cartridges are installed.
Once you have installed the FINE Cartridges, the POWER lamp will flash green. Wait for about
one to two minutes until the POWER lamp displays a steady green light and the printer has
stopped making operating noises before proceeding.
Notes
Do not drop or shake FINE Cartridges as this may cause the ink to leak out and stain your
clothes and hands.
The ALARM lamp on the printer still flashes orange if a FINE Cartridge is not installed properly.
Open the Front Cover and make sure that all the FINE Cartridges are installed in the correct
order directed on the label.
2
Preparing the Printer