Panasonic EY7542 Bedienungsanleitung Seite 13

To Change the Belt Hook
Location Side
The belt hook can be attached to
either side of the unit.
1. Loosen the screw turning it coun-
ter-clockwise, using a flat metal or
a flat blade screw driver.
2. Take out the belt hook and insert
into the other side of the slot on the
main unit.
3. Fasten the screw firmly, turning it
clockwise.
Control Panel
(1)
(1) LED light
Before the use of LED
light, always pull the power
switch once.
Press
button.
The light illuminates with
very low current, and it
does not adversely affect the perfor-
mance of the driver during use or its bat-
tery capacity.
CAUTION:
• The built-in LED light is designed to
illuminate the small work area tem-
porarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
• LED light turn off when the tool has
not been used for 5 minutes.
Caution : DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.
EY7542(EU).indb 13
(2) Overheat warning lamp
(3)
(2)
the LED light on
- 13 -
Off Flashing: Overheat
(normal
Indicates operation has
operation)
been halted due to battery
overheating.
The overheating protection feature
halts driver operation to protect the
battery pack in the event of over-
heating. The overheat warning lamp
on the control panel flashes when
this feature is active.
• If the overheating protection feature
activates, allow the driver to cool
thoroughly (at least 30 minutes).
The driver is ready for use when the
overheat warning lamp goes out.
• Avoid using the driver in a way that
causes the overheating protection
feature to activate repeatedly.
• The ambient temperature range
is between 0°C (32°F) and 40°C
(104°F).
If the battery pack is used when the
battery temperature is below 0°C
(32°F), the tool may fail to function
properly.
• When charging a cool battery pack
(below 0°C (32°F)) in a warm place,
leave the battery pack at the place
and wait for more than one hour to
warm up the battery to the level of
the ambient temperature.
• If the tool is used in cold-temperature
conditions (such as during winter) or
if it is frequently stopped during use,
the overheating protection feature
may not activate.
The performance of the EY9L42
de-teriorates significantly at and
below 10°C due to work conditions
and other factors.
2012-10-12 15:38:32