Maintenance - Gardena ClassicCut Li Betriebsanleitung

3. Hold the handle ß on the telescopic handle, push the
2h
ß
starting lockout on the telescopic handle forward and
5h
pull the start lever ß
6h
The battery shear starts.
4. Release the starting lockout

3. MAINTENANCE

DANGER! Risk of injury!
Cut injury when the product starts
accidentally.
v Wait for the blade to stop and slide the protective
cover over the blade before you maintain the
product.
To clean the battery shear [Fig. M1]:
DANGER! Risk of injury!
Risk of injury and risk of damage to the
product.
1. Do not clean the product with water or with
a water jet (in particular high-pressure water jet).
2. Do not clean with chemicals including petrol or
solvents. Some can destroy critical plastic parts.
9853-20.960.01 A6 Short.indb 29
on the telescopic handle.
ß
again.
5h
To stop:
1. Release the two start lever
The battery shear stops.
2. Wait for the blade to stop and slide the protective cover
over the blade.
(3)
1. Push both lock buttons
(4)
the blade .
2. Clean the product with a damp cloth.
3. Spray the blade with the GARDENA Cleaning Spray,
Art. 2366.
Avoid contact of the oil with the plastic parts.
(4)
4. Place the blade again.
To clean the charging power supply:
Make sure that the surface and the contacts of the charging
socket and the charging power supply always are clean and
dry before you connect the charging power supply.
Do not use running water.
Clean the contacts and the plastic parts with a soft and dry
cloth.
(6) ß
/ .
6h
at the same time and remove
29
06.08.18 13:37