Computer Configuration; Asio Driver Installation - Reloop Jockey 3 Remix Bedienungsanleitung

3. Computer Configuration

Before you can use your new device a few basic computer adjustments have to be carried out.
ATTenTIOn! Please make sure that your Reloop Jockey 3 Remix is still turned off. You will be asked during the installation to turn the device
on. The included USB cable can already be connected.
Please pay special attention to the following explanations.

3.1 ASIO driver Installation

Insert the included installation CD in your computer's drive. Select the driver that best suits your system in the "Drivers" folder and start the
installation via a double click.
TIP! Reloop regularly provides updated drivers online. For more information please read the chapter "Updates & Support".
nOTe! Please make sure to start the driver installation with admin rights. Otherwise the installation will fail with an error message.
When using Windows Vista or Windows 7 please carry out the appropriate installation setup via a click of the right mouse button. Then select "Run
as admin".
1. First of all you will enter the language select window. Please select your preferred language.
2. Now click on the "Install the driver" button.
3. You will then be asked to connect and turn on your Reloop Jockey 3 Remix. If your Reloop Jockey 3 Remix is not connected via USB yet, please
connect the included USB cable to the USB port -B57- and a free USB port of your computer. Also connect the included mains adapter to the
corresponding connector -B55-.
Now turn on the device via the ON/Off Button -B56-.
4. The installation will be continued. As soon as the installation has been carried out successfully you can close the setup via the "Finish" button.
A reboot is not necessary.
22