Warranty - Leister ELECTRON ST Bedienungsanleitung

Warning
DANGER! Danger when opening up the tool, as live components and
connections are exposed. Therefore, before opening it, unplug the tool
to ensure disconnection from the mains. Before putting into operation,
check power supply cord and connector as well as extension cable for
electrical and mechanical damage.
Incorrect use of the hand extruder (eg overheating of the material) can
present a fire and explosion hazard, especially near combus t ible
materials and explosive gases.
Do not touch the element housing, air nozzle and discharging
plastizised material when they are hot as they can cause burns.
Let the tool cool down. Do not point the hot air flow and the
discharg ing plastizised material in the direction of people or animals.
Caution
The voltage rating stated on the tool must correspond to the mains
voltage.
For personal protection on building sites we strongly recommend
the tool be connected to a RCCB (Residual Current Circuit Breaker).
The tool must be operated under supervision. Heat can ignite
flammable materials which are not in view.The machine may only be
used by qualified specialists or under their supervision. Children
are not authorized to use this machine.
Protect tool from damp and wet.
Repairs should only be carried out by authorized Leister service
points. Restricted to use with original Leister accessories and
replacement parts.
Translation of the Original User Manual

Warranty

• For this tool, the guarantee or warranty rights granted by the relevant distri-
butor/seller shall apply. In case of guarantee or warranty claims any manu-
facturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verified by
an invoice or a delivery document. Heating elements shall be excluded from
warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandato-
ry provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and
tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered
or changed by the purchaser.
Conformity
Leister Technologies AG, Galileo-Strasse 10, 6056 Kaegiswil/Switzerland,
confirms that this product, in the version as brought into circulation through
us, fulfils the requirements of the following EC directives.
Directives:
Harmonized Standards:
Kaegiswil, 11.11.2014
Bruno von Wyl, CTO
Disposal
EC on waste electrical and electronic equipment and its incorporation into national law,
power tools that are no longer suitable for use must be separately collected and sent
for recovery in an environmental-friendly manner.
2006/42, 2004/108, 2006/95, 2011/65
EN 12100
EN 55014-1, EN 55014-2, EN 61000-6-2,
EN 61000-3-2, EN 61000-3-3, EN 62233
EN 60335-1, EN 60335-2-45, EN 50581
Andreas Kathriner, GM
Power tools, accessories and packaging should be sorted for environmen
tal-friendly recycling. Only for EC countries: Do not dispose of power
tools into household waste! According to the European Directive 2002/96/
Deutsch
English
Français
Español
Português
Italiano
Nederland
Dansk
Svenska
Norsk
Suomi
Eλληνικά
Türkçe
Polski
Magyar
Česky
Slovensky
Românã
Slovensko
Български
Eesti
Lietuviu
Latviešu
Русский
日本語
7