Important Safety Instructions - Leister ELECTRON ST Bedienungsanleitung

Important safety instructions

This appliance has a polarized plug (one blade is wider than the other). To reduce
the risk of electric shock, this plug is intended to fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,
Deutsch
contact a qualified electrician. Do not modify the plug in any way.
English
Français
Read these instructions
Español
Português
Warning: Extreme care should be taken when stripping paint. The peelings, residue
Italiano and vapors of paint may contain lead, which is poisonous. Any pre-1977 paint may
Nederland contain lead and paint applied to homes prior to 1950 is likely to contain lead. Once
Dansk deposited on surfaces, hand to mouth contact can result in the ingestion of lead.
Svenska Exposure to even low levels of lead can cause irreversible brain and nervous system
Norsk damage; young and unborn children are particularly vulnerable.
Suomi
Before beginning any paint removal process you should determine whether the paint
Eλληνικά
you are removing contains lead. This can be done by your local health department or
Türkçe
by a professional who uses a paint analyzer to check the lead content of the paint to
Polski
be removed. LEAD-BASED PAINT SHOULD ONLY BE REMOVED BY A PROFESSIONAL
Magyar
AND SHOULD NOT BE REMOVED USING A HEAT GUN.
Česky
Slovensky Persons removing paint should follow these guidelines:
Românã 1. Move the work piece outdoors. If this is not possible, keep the work area
Slovensko well ventilated. Open the windows and put an exhaust fan in one of them.
Български Be sure the fan is moving the air from inside to outside.
Eesti
2. Remove or cover any carpets, rugs, furniture, clothing, cooking utensils
Lietuviu
and air ducts.
Latviešu
Русский 3. Place drop cloths in the work area to catch any paint chips or peelings. Wear
日本語
protective clothing such as extra work shirts, overalls and hats.
4. Work in one room at a time. Furnishings should be removed or placed in the
center of the room and covered. Work areas should be sealed off from the
rest of the dwelling by sealing doorways with drop cloths.
8
Translation of the Original User Manual
5. Children, pregnant or potentially pregnant women and nursing mothers
should not be present in the work area until the work is done and all clean
up is complete.
6. Wear dust respirator mask or a dual filter (dust and fume) respirator mask
which has been approved by the Occupational Safety and Health Adminis-
tration (OSHA), the National Institute of Safety and Health (NIOSH), or the
United States Bureau of Mines. These masks and replaceable filters are
readily available at major hardware stores. Be sure the mask fits. Beards
and facial hair may keep masks from sealing properly. Change filters often.
DISPOSABLE PAPER MASKS ARE NOT ADEQUATE.
7. Use caution when operating the heat gun. Keep the heat gun moving as
excessive heat will generate fumes which can be inhaled by the operator.
8. Keep food and drink out of the work area. Wash hands, arms and face
and rinse mouth before eating or drinking. Do not smoke or chew gum or
tobacco in the work area.
9. Clean up all removed paint and dust by wet mopping the floors. Use a wet
cloth to clean all walls, sills and any other surface where paint or dust is
clinging. DO NOT SWEEP, DRY DUST OR VACUUM. Use a high phosphate
detergent or trisodium phosphate (TSP) to wash and mop areas.
10. At the end of each work session put the paint chips and debris in a double
plastic bag, close it with tape or twist ties and dispose of properly.
11. Remove protective clothing and work shoes in the work area to avoid carrying
dust into the rest to the dwelling. Wash work clothes separately. Wipe shoes
off with a wet rag that is then washed with the work clothes. Wash hair and
body thoroughly with soap and water.
SAVE THESE INSTRUCTIONS