Ayce 3124.1 Originalbetriebsanleitung Seite 83

c. Mounting the dust extraction tube (Fig.3)
!
Always connect the dust extraction when sawing.
WARNING
Fig. 3
d. Pendulum lever (Fig.4)
Fig. 4
• To install the dust extraction tube,
just insert the tube into the rear
part of the jig saw.
• A standard household vacuum
cleaner can be connected with the
tube.
• The pendulum lever has four
positions. The first position selects
normal cutting without pendulum
action. The positions (1, 2 and 3)
cause the blade to swing slightly
backwards and forwards as it cuts.
This pendulum action increases the
efficiency of cutting, set the
pendulum lever to one of the three
settings (1, 2 or 3) according to
degree of pendulum action
required.
• Experiment on a piece of scrap
material to determine the optimum
pendulum action setting for the
material of the work-piece.
Recommendations (non-committal):
1. No pendulum action for: cutting
sheet metal, plastic sheets; very
fine cutting edges.
2. Low pendulum action for: cutting
hard wood, plastics; fine cutting
edges on wood.
82 | 83 GB