AGP DM62 Bedienungsanleitung Seite 7

adjust when the machine is at rest.
Select the desired gear range by pressing the release button and then turning the gear selector either
clockwise or counterclockwise into the desired gear. It will usually be necessary to turn the spindle by hand a
little to get it to shift all the way.
DM62-DRY DRILLING RECOMMENDED GEARS (soft materials)
BitØ
52mm
Gear
Gear 2
Gear 1
DM62-DRY DRILLING RECOMMENDED GEARS (reinforced concrete)
BitØ
24mm
Gang
Gear 2
Gear 1
Impossible /
Not recommended
PERCUSSION SELECTOR
The percussion function can be turned on and off.
To select , push the button on the side with the "Hammer" symbol for soft percussion or the "No Hammer"
symbol to turn the percussion OFF. NOTE: When turning the percussion OFF, it is usually necessary to first pull
the spindle to allow button to release.
The main purpose of soft percussion function on this machine is to keep the diamond segments sharp. If the
bit is staying sharp without it, the percussion function may be turned off. If the bit glazes easily, it should be
turned on.
THE SWITCH
The machine has a lockable trigger switch. Squeeze the trigger to start
the machine. To lock the switch on, press the lock button while holding
the trigger switch on. To release, squeeze the trigger and release.
WARNING: Never lock the switch on when drilling hand-held. Only
lock the switch on when mounted to a rig.
92mm
45mm
Possible
GB
162mm
122mm
Ideal
7
232mm 262mm
162mm 182mm
Lock Button
Trigger Switch