AGP DM62 Bedienungsanleitung Seite 6

ASSEMBLY
Mount the handle clamp of the side handle onto the gearbox neck. Position the side handle perpendicular to
the main handle. Use the lock screw to tighten the clamp.
LIST OF CONTENTS
• Diamond core drilling machine.
• Side handle assembly
• Vacuum adaptor (optional)
OPERATING INSTRUCTIONS
Mounting the core bit
CAUTION: Ensure that the threads of the spindle and the core bit match. Attempting to mount
mismatched threads will result in damage to both threads.
Ensure both the core bit and the machine spindle are clean. Any debris could cause excessive run-out of the
mounted core bit. Excessive run-out can cause premature failure of the core bit and/or a safety hazard.
Tighten the bit to the spindle using two wrenches. Only use correct sized wrenches to avoid damage to the
spindle or bit.
Choosing the correct core bit for the job:
Ensure that the bit you are using is suitable for the material you are drilling. There are two main types of
diamond core bit:
Dry bits and wet bits. This machine should only be used with dry bits.
DRY DRILLING
Dry drilling is a different process from wet drilling.
When dry drilling, you must not push too hard. Allow the tool to work at its own pace.
Dry drilling is normally done in softer materials. This machine may also drill dry in reinforced concrete using
special dry diamond core bits.
DRY DRILLING OF REINFORCED CONCRETE
This requires the use of special diamond core bits designed for this application.
Effective dust collection is essential for this process.
Use the soft percussion function.
Always use a drill stand for diameters above 80mm.
SELECTING SPEEDS
There are 2 speed ranges to suit the bit size and work piece hardness.
CAUTION: Never attempt to change gears on a running machine! Only
GB
6
Release Button
Gear Selector