Whirlpool AKR 471 Benutzer- Und Wartungshandbuch Seite 15

INSTALLATION - ASSEMBLY INSTRUCTIONS
The instructions below, to be carried out in the order in which they are numbered, refer to the figures (with the same step numbers) given on the last pages of
this manual.
Note: Some instructions differ depending on the hood body width and height, in which case installation differences are described both in the text and in the
figures.
1. Mark a line on the wall right up to the ceiling, corresponding to the centre-line of the hood.
2. Cut the template along the line H6 or H10 (depending on whether the body of the hood you have purchased is 6 cm or 10 cm high) and attach the hole
diagram to the wall (using adhesive tape): the vertical centre line printed on the hole diagram must match the centre line drawn on the wall, and the lower
horizontal edge of the hole diagram must match the lower edge of the hood.
Drill a hole.
3. Remove the hole diagram, and insert plugs and screws as shown.
4. Partially tighten the screws
5. Place the flue support bracket on the wall, against the ceiling. Drill and insert the wall plugs as indicated. Fix the bracket.
6. For Extractor Version only - rear exhaust outlet: Make an opening on the wall for the exhaust pipe.
7. For Extractor Version only - ceiling exhaust outlet: Make an opening in the ceiling for the exhaust pipe.
8. Prepare the electrical connection to the mains power supply.
9. For Filter Version only: Fix the deflector to the flue support bracket.
10. Remove the grease filter/s.
11. Remove the adhesive tape holding the control electronics box to the motor body.
Note: the figure is indicative only, the box may be temporarily fixed to other sides of the motor body.
12. Hook the hood to the wall.
13. Adjust the hood horizontally.
14. Adjust the distance between the hood and the wall.
15. Mark the hole/s for the final fixing of the hood as shown.
16. Remove the hood from the wall.
17. Drill and insert the wall plugs as shown.
18. Rehook the hood to the wall.
19. Fix the hood to the wall with screws as shown.
20. Fix the collar to the exhaust outlet.
21. Fully tighten the screws fixing the box to the motor body.
Note: the box is of two types, either front fixing or rear fixing. Follow the instructions in the figures (21a and 21b) depending on the model you have
purchased).
22. Slide the power supply cable into its housing.
23. Secure the cable with a cable clamp.
IMPORTANT: It is essential to carry out this operation in order to avoid accidental disconnection of the cable.
Carry out the electrical connection to the mains power supply.
24. Connect an exhaust pipe to the collar; the fumes must be ducted to the outside (extractor version) or towards the deflector (filter version).
25. Fit the flues over the extractor unit, engaging them in their seat above the hood.
26. Slide the top section upwards and fix the flues with the screws as shown.
27. Fit the carbon filter (Filter Version only) andrefit the grease filter/s.
Check for correct hood operation, referring to the hood description and use section.
GB13