VOLTOMAT HEATING FH-109313.2 Bedienungsanleitung Seite 82

FH-109313.1 & FH-109313.2 GBR
PARTS DESCRIPTION
1. Control panel
2. Digital display
3. Remote control
4. Air outlet
5. Base
6. Wi-Fi button
7. Remote control storage
8. Air inlet
9. Filter
10. Air inlet grille
11. Power switch
Control panel
1. On/off button
2. Oscillation button
3. Timer / Temperature button
4. Power setting button
5. Adjustment button
6. ECO button
ASSEMBLY
Remove the appliance from the packaging. Upside the appliance body. Attach the base onto the bottom of the
body and fix with the four tabs buckled firmly.
OPERATION
Plug in the appliance into an appropriate electrical outlet. Turn on the appliance by pressing the power switch.
A beep sound will be heard. The appliance is standby with the icon " " illuminate on the digital display. Press
the on/off button on the control panel to start setting your heater.
1. On/off button
Press the button " " to run your heater under low heating power with icon " " illuminating on digital
display. The digital display shows the room temperature and the set temperature is 25℃ by default. Once the
set temperature is reached, the appliance will stop working. Press the button " " again, the digital display
will count down from 10 to 0 to shut down the appliance. The appliance will be under standby condition again.
2. Oscillation button
Under working condition, you can press button " " to activate or deactivate the swing function. The digital
display will show icon " " lighted on when swing function is activated.
3. Timer / Temperature button
Under working condition, you can press button " " to set timer and temperature.
Timer: Press the button " " once, the appliance enters into the timer setting mode. You can press " "
to adjust the timer from 0 – 12H. The corresponding timer value will be shown on the digital display. The set
- 80 -