Alarm Mode - TFA HiTRAX Bedienungsanleitung

To clear all runs
Hold down D until "----" is shown on the display.
* All runs are cleared.

ALARM MODE

Use C to enter Alarm mode.
* Mode prompt "ALRM" is displayed first.
- There are 2 daily alarms and they can be set to refer to Normal Time (indicated by T1) or Dual Time (indicated
by T2).
- Daily alarm sounds at the same time each day, while it is turned on.
- The alarm sounds at the preset time for about 20 seconds, or until y ou stop it by pressing any button.
- The alarm on indicator is only displayed at the time mode that the alarm is set to refer to.
- Hourly chime sounds at every full hour, while it is turned on.
* If chime is turned on, confirmation sound will be given w henever a button is pressed.
To switch between alarm 1 and alarm 2
Press B to switch between alarm 1 (indicated by AL -1) and alarm 2 (indicated by AL-2).
To set alarm time and turn chime on and off
1. Hold down D until the hour digits start to flash on the d isplay, which indicates the setting screen.
2. Use A (+) and B (-) to change the setting. Holding down either button scrolls the setting at high speed.
3. Press C to advance to the next setting as in the following:
C
HOUR MINUTE
* When TIME 1 or TIME 2 is flashing, press A or B to switch between setting the alarm to refer to Normal Time
(TIME 1) and Dual Time (TIME 2).
* When ON or OFF is flashing, press A or B to turn the chime on (indicated by ON) and off (indicated by OFF).
If chime is t urned on, the chime on indicator will be shown after exiting setting screen.
4. Press D to exit the setting screen.
* The alarm turns on, which is indicated by ON and the appearance of the alarm on indicator.
* If there is no button operation for 2 -3 minutes at setting screen, the display will return to Alarm mode
automatically.
C
C
C
REFER TO T1/T2 CHIME ON/OFF
14