Manufacturer's Plate; Fittings; Assembly Instructions / Inflation - Sevylor WABASH Bedienungsanleitung

MANUFACTURER'S PLATE

Part of the information is marked on the manufacturer's plate affixed on the kayak. The symbols used have the following
meaning:

FITTINGS

Illustration model: WABASH™
Main chamber with
Boston valve
Bottom chamber with
mini Boston valve
Boston
Drain plug
Transport
handle
Main chamber with
Boston valve
E
N
G
L
I
1/ Removable directional fin under the kayak – refer to the assembly instructions.
S
H
All models are supplied with a pressure gauge, a repair kit and a carry bag.

ASSEMBLY INSTRUCTIONS / INFLATION

 Do not use a sharp tool !
 Any use of an air compressor will damage your product and automatically void all warranties.
 Do not open the zippered closing that provides access to the inflatable inner chambers when the kayak is
inflated.
For the first inflation and in order to get acquainted with your new product, inflate indoors at room temperature where the
PVC will be soft and assembly process made easier.
If it was stored at a temperature below 0° C / 32° F, leave it at 20° C / 68° F for 12 hours before unfolding. Inflate it with a
®
Sevylor inflator or any inflator designed for kayaks, pool floats, air beds, camping mattresses, and other low pressure
inflatables. These types of inflators will have a hose and adapters to fit the valves on this product.
Choose a smooth and clean surface to unfold your kayak.
1. Fix the directional fin to the bottom, folding the outer hull. Insert the ends of the fin into each of the holders provided
and tauten the outer hull as much as possible to secure it. This operation is not possible when the kayak has been
inflated. The curve of the fin must be towards the stern of the kayak.
Kayak
Maximum number of people on
board
Read the manufacturer's manual
before use
Removable
1
directional fin
2
1
3
2
Adjustable bucket seats with
mini double lock valves
3
Handles
WARNING!
4
Maximum transportable
load capacity
Recommended service
pressure
Do not use a compressor
Zip fastener for opening the
polyester outer hull and
accessing the PVC inner
chamber (bow and stern)
Transport
handle
Directional strakes
moulded on the bottom
Figure. 1