Troubleshooting - steute RF RxT SW868-NET-M Montage- Und Anschlussanleitung

RF RxT SW868/915/917/922-NET-M
//
Montage- und Anschlussanleitung / sWave.NET Gateway mit Sensor Bridge und Access Point
Mounting and wiring instructions / sWave.NET Gateway with Sensor Bridge and Access Point
English
Password settings
To change the admin or api passwords:
- Login as admin user.
- Select the menu »User Settings«.
Fig. 5: User settings
Basic setup
Once the network and login settings are adjusted, the following
steps are required for a minimal system configuration:
- Create a managed group.
- Assign switches to this group.
Please refer to the product website at www.steute.com for a
detailed description.

Troubleshooting

Error Cause
Mode LED is off No power supply or
internal power sup-
ply unit defective
Ethernet LED is off No network cable,
defective network
cable; network
remote station
inactive
Configuration No network connec-
website cannot be tion established or
displayed Gateway IP and PC
IP not in the same
subnet
Access Point re- Switch out of
ceives no wireless range; antenna not
telegrams properly mounted;
wireless receiver
defective
Maintenance / Cleaning
We recommend regular maintenance as follows:
1. Remove dirt
Clean enclosure on the outside only. Clean with household cleaning
agents. Do not use compressed air to clean.
Disposal
- Observe national, local and legal regulations concerning disposal.
- Recycle each material separately.
Notices
The electrical connection may only be carried out by authorised per-
sonnel. The wireless receiver must not be used in connection with
devices that may directly or indirectly serve health- or life-saving
purposes or cause hazards by operation to human beings, animals
or asset values.
Subject to technical modifications.
The responsibility taken by the manufacturer of a plant or machine
implies a safeguarding of correct general function. Moreover, steute
does not assume any liability for recommendations made or implied
by this description. From this description new claims for guarantee,
warranty or liability cannot be derived beyond the general terms and
conditions of delivery.
7 / 16
Solution
Check power supply,
replace device
Change network
cable; turn on/check
network router or
switch
Check network con-
nection (Ethernet
LED) or adjust PC IP
and reset Gateway
to default settings
Check distance
to switch; check
antenna; replace
device