Sorting Out The Bridle - Flysurfer SPEED4 Bedienungsanleitung

When the bridle is sorted out, lay the
front lines to the inside and the steering
lines to the outside. If not, follow the tips
on the "Sorting out the bridle" chapter.
Sort out your flying lines. Check
for any damage or knots.
Exception: There is a "stop-
per" knot that prevents the
bar from sliding up too far
when released.
Tip: The bridle can
also be checked before
unrolling the flying
lines. It can then be
sorted out quickly.
If the lines are still twisted, unt-
wist them by turning the bar. It may
be possible (especially after not being
careful when packing away or setting up
the kite) that the bar has to be pushed
through the lines again to untwist.

02.02 Sorting out the bridle

Even a badly tangled bridle can be
quickly sorted out with the right tech-
nique. If the bridle is tangled, it was
probably caused by mistakes made
when packing or setting up the kite.
Roll up your lines onto the bar
until you get close to the mixer
and secure the lines with a half
hitch and/or the bungie cord.
43
EN