Hama Dashcam 60 Bedienungsanleitung Seite 8

Note
• Before mounting the holder, check the installation options in your vehicle. If in doubt, consult the
manual for your vehicle or contact the manufacturer.
• Never apply force when using the product or during installation.
• Check that the product is safely mounted before beginning your journey
6.1 Mounting the suction cup holder
• Remove the protective film from the suction cup.
• Open the locking lever (13) of the suction cup.
• Position the holder with the suction cup on a clean, even mounting surface (e.g. glass pane).
• Lightly press the holder onto the desired mounting surface and close the locking lever (13) to fasten
the holder.
• After mounting, always check to ensure the suction cup is securely attached.
• To remove the suction cup from the surface, open the locking lever. Then gently pull the flap to
completely release the suction cup.
6.2 Setting angle and tilt
The viewing angle and tilt of the holder can be continuously adjusted using a ball head.
• Always set the angle and tilt without the terminal device inserted.
• Loosen the clamping screw of the ball head.
• Set the angle and tilt as desired and tighten the clamping screw.
6.3 Inserting/removing the Dashcam
Note
Continually check that the suction cup holder is securely seated and the Dashcam is securely held.
• Slide the Dashcam into the holder (12) of the suction cup holder.
• Pull the Dashcam out of the holder by carefully moving the Dashcam to and fro.
6