Operating The Modelling Lamp - Walimex Pro Operator TTL Funkfernsteuerung

7.9 Operating the modelling lamp

Use the radio transmitter to remotely control the brightness of the modelling
lamp; the lamp is dimmable in six stages.
Briefly press the [MODEL/AF] button to set up the modelling lamp for group A, B,
and C in sequence.
1. Set modelling lamp for group A: Briefly press the [MODEL/AF] button; the
LCD screen only shows the modelling lamp value for group A. Rotate the
dial and set the correct modelling lamp output 1/2/3/4/5/6/OFF. Press [OK]
to save settings.
2. Set modelling lamp for group B: Briefly press the [MODEL/AF] button
again; the LCD screen only shows the modelling lamp value for group B.
Rotate the dial and set the correct modelling lamp output 1/2/3/4/5/6/OFF.
Press [OK] to save settings.
3. Set modelling lamp for group C: Briefly press the [MODEL/AF] button
again; the LCD screen only shows the modelling lamp value for group C.
Rotate the dial and set the correct modelling lamp output 1/2/3/4/5/6/OFF.
Press [OK] to save settings.
NOTICE
The feature that remotely controls the modelling lamp is only applicable to
a few series of the Walimex pro flashes. It is not applicable to other brands
of flashes.
43