Fellowes Easy Glide Montageanleitung Seite 2

SAFETY INSTRUCTIONS/WARNING
Ensure that the sit stand is anchored tightly to the desk/table before using it to prevent injury or damage to the product!
CAUTION: DO NOT EXCEED MAXIMUM LISTED WEIGHT CAPACITY.
SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR!
• Make sure the desk or mounting surface can support the combined weight of the sit
stand and screens.
• DO NOT lean on the keyboard platform
• DO NOT place heavy items on the keyboard platform.
• Maximum desk thickness: 2" (50mm) / Minimum desk thickness: .3" (8mm).
PARTS REQUIRED
A (1) Dynamic Arm
A
B (1) Lower Arm
C (1) Keyboard Platform
D (1) Rubber Bumper
E (1) Base
F (1) VESA Plate
G (1) Plastic Washer
H (1) Metal Washer
F
I (1) M8 x 20mm Counter Bore Screw
J (2) M6 x 25mm Counter Bore Screw
K (4) M6 x 12mm Counter Bore Screw
L (3) M6 x 10mm Counter Bore Screw
M (1) M6 x 8mm Counter Bore Screw
L
N (4) M4 x 10mm Pan Head Phillips Screws
O (1) Hex Allen Key 2.5mm
P (1) Hex Allen Key 5mm
Q (1) Hex Allen Key 6mm
R (1) 8mm Torque Adjust Socket
S (4) M6 x 16mm Counter Sunk Screw
R
T (1) Front 90 Degree Bracket
U (1) Mounting Plate
8 mm
V (4) M6 x 12mm Counter Bore Screw 1/4" Drive
W (2) Adhesive Strip (Optional to attach
keyboard)
W
X (1) Rubber Gasket
Other Tools Required
Socket Wrench
Phillips Screw Driver
2
Easy Glide™ Sit-Stand Work Platform
Monitor ≤ 8 kg (17.6 lbs)
Tray ≤ 2.5 kg (5.50 lbs)
B C D
G H I J
M N O P
2.5mm
5 mm
S T U
X
ASSEMBLY
ENGLISH
STEP 1
Assemble Base and Attach to Table
• Attach the base to the Front 90 Degree Bracket using four M6 x 16mm Counter Sunk Screws
• Attach the Rubber Gasket
• Slide the base with bracket attached onto the desk
• Attach the Mounting Plate using four M6 x 12mm Counter Bore Screws
• Tighten the clamp feet onto the desk
E
S
T
E
STEP 2
Insert the Dynamic Arm
• Place the Dynamic Arm into the socket on the base
• Secure the Dynamic Arm using the M8 x 20mm Counter Bore
Screw, along with the Metal Washer and the Plastic Washer
K
Q
6 mm STEP 3
Attach Keyboard Platform to Lower Arm
• Place the Lower Arm into the socket on the Keyboard Platform
V
6 mm
• Secure the Lower Arm using four M6 x 12mm Counter Bore
Screws
X Min. 8.0 mm
Q
6 mm
A
E
P
5 mm
U
P
V
Q
I
H
G
B
C
K
3