Accuracy Check - CONDTROL XLiner DUO/COMBO 360 Bedienungsanleitung

CROSS
EN
LINE LASER
Short press button to switch on/off pulse mode that allows
working with laser receiver. In this mode pulse mode indicator will
turn red.
To switch the laser level off short press button
until all laser planes are off.
Attention! To increase operating time and avoid the risk of
unintentional blindness switch the laser on only when you are ready
to work.
If operated near objects or air streams with the temperature different
from the environment the laser line may tremble due to heterogeneity
of the atmosphere. The longer the distance, the more trembling of the
laser line can be observed.
The width of the laser line increases as soon as operating distance
increases as well. The layout should be made along the axis of the laser
line. For maximum accuracy, use the middle portion of the laser line.
It should be noted that the shape of the laser line on the object's
surface (e.g., walls, ceilings, etc.) depends on the curvature and tilt of
the surface relative to the laser plane.
10
XLiner Duo/Combo 360
user manual
several times
CROSS
EN
LINE LASER

ACCURACY CHECK

Check of horizontal line
Check of horizontal line is carried out by using 2 walls A and B located
opposite each other at 5m distance.
1. Install the laser level as close as possible to wall A (see Fig.A). Unlock
compensator and switch on vertical and horizontal lines. Expand the
device emitters in the direction of wall A so that the crossing of the
laser lines on the wall is located in front of the laser level. Mark the
crossing point of laser lines as A1. Mark point B on the wall B.
2. Turn the instrument by 90°. Check misalignment of horizontal line
and point B1 (see Fig. B). If deviation between the laser line and the B1
mark exceeds 1 mm, please contact service center.
3. Repeat step 2 for 2 more times, turning the laser level in one
direction.
A
XLiner Duo/Combo 360
user manual
11